There have been problems with P1101 set in the Cruze or Sonic with the 1.4 turbo engine.

General Motors and US Environmental Protection Agency emissions testing found vehicles that did not comply with the carbon monoxide emissions standard on the US06 emissions test. General Motors has decided to conduct a voluntary emission recall of 2011-2013 Chevrolet Cruze vehicles equipped with a 1.4L engine (RPO LUJ or LUV) and an automatic transmission. Reprogram Engine Control Module Carbon Monoxide Emissions - 2011-2013 Chevrolet CruzeĮquipped with 1.4L Engine (RPO LUJ and LUV) and Automatic Transmission He replaced the gasket, no exhaust leak and the code does not reset. The Tech smoke tested the exhaust system and found an exhaust leak where the cat bolts to the exhaust manifold. The scan tool P0420 - Catalyst System Low Efficiency.Ĭampaign 14801A (Emissions Reflash) was completed at GM dealer.įreeze Frame data is inconclusive, shows code set at 700 RPM, fully warmed up, off-idle throttle. The customer returned after the catalytic converter was replaced and the P0420 reset. I installed the new ECU into the car and read it with KESS v2 (please see file ECU read KESS), I don't know if KESS read the whole memory or only partial part of it.ġ) If the AMD 29F800BB dump that I read with the programmer is OK and will work if I will write it back to the new ECU using KESS.Ģ) If KESS was able to read the whole memory so for the next time I won't need to open the ECU's.All equipped with 1.4L engine Community Repair Questions The only option is to swap or to clone the memory, I looked into the board tried to find a simple SMD8 EEPROM chip but there is no chip like that, I went trough all the chip on the PCB and the only memory chip is the: AMD 29F800BB, I removed the chip from the board of the old (defective) ECU and read it with programmer, please see file: 'AMD 29F800BB - read', I did not write the dump to the new ECU and I did not swap the chips between the 2 ECU's yet. I got a used ECU from a junk yard from the same car with the same part numbers,I put it in the car but no start, I tried to decode the VIN to the new ECU with AVDI but still no start, I tried to reprogram the keys using AVDI but still no start.

I opened the ECU and found bad circuit and corrosion on the PCB - ECU is defective. GM ECU/ECM Part number: please see attached pictures.

P061A - Computer and Auxiliary Outputs - ISO/SAE Controlled P0605 - Internal Control Module Read Only Memory (ROM) Error I got a 2010 Chevy Cruze (EU) with bad ECU (water damage), Engine will not start. Hello everyone and thank you in advance for your help.

Holden cruze ecu reprogramming tool